Switchport mode hybrid Creating a Data/Voice VLAN Switchport hybrid egress-tag all except-native Switchport hybrid acceptable-frame0type all When viewed through the CLI, this is what the configuration looks like for a hybrid port: Int FastEthernet 1/1 Ports configured in hybrid mode manage the tagging of outgoing frames, applying or removing tags as configured.Hybrid ports accept both tagged and untagged frames.In hybrid mode, the PVID is referred to as the 'native VLAN' The port VLAN ID, or Port VLAN ID (PVID), determines the VLAN ID for untagged traffic on a port.A hybrid port allows for the switching of packets tagged with VLAN ID 0, which is not possible on trunk ports (the VLAN ID range supported is 0 - 4095 Profinet often uses VLAN 0).Hybrid mode is similar to trunk mode, but with the distinction that by default, a hybrid port is a member of all VLANs.Hybrid: This is an additional port mode supported on the switches.Trunk: A trunk port allows traffic from multiple VLANs.Access: A port configured in access mode permits traffic from one specific VLAN.Ports on IE switches can operate in three modes: Although CLI access is available via SSH, it is intended solely for debugging purposes rather than for configuration. These switches do not come with a Console port, which means that the primary method for configuring them is through the GUI. The Cisco Industrial Ethernet (IE) 1000 series switches are classified as 'Lightly Managed' devices. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment.

The information in this document pertains to Cisco IE1000 switches and IP phones and is applicable across all versions without being restricted to any specific software or hardware versions. Prerequisites RequirementsĪ fundamental knowledge of VLAN concepts, along with an understanding of voice and data VLANs and switch port configurations, is required. This document describes the process for creating and assigning a Voice VLAN to a port operating in hybrid mode on Cisco IE 1000 series switches.

Assign ports to blackhole vlan